Adding Insulation to your Attic is Quick and Easy.
Blowing the insulation should take less than 1.5 hours and the whole job can be completed in less than 4 hours based on a 1,000 sq. ft. attic at R-30.
Blowing it in allows us to put insulation exactly where we want it, and in hard to reach areas.
Northwest Construction we cut-in through your roof so there is absolutely No Mess.
To schedule a free evaluation of your attic insulation please call us 313-277-7676 or fill out the contact form below and we will contact you and schedule and appointment.
Save Money, Save Energy, and Help Save the Environment by Adding Insulation to your Attic with Expanding Blown-In PINK Fiberglas™ Breaking your attic insulation it up and fluffing it, adds millions of tiny air pockets, and it is these air pockets that give the material its insulating power.
The insulation is conditioned further throughout the length of the hose, and as it bounces its way up to your attic, more and more air pockets are added, increasing its insulating power even more. And since Fiberglas™ insulation will not settle, it will keep its energy-saving R-value over time.
Ice Dams are just a symptom. The problem (or cause) is usually one, or a combination of a couple of different factors:
> Not Enough Attic Insulation
> Poor Attic Ventilation – (Intake and Exhaust)
> Missing Insulation Baffles
> Improper Kitchen and/or Bath Exhaust Ducts
Remember last Winter? We sure do! Last winter was MISERABLE in Metro Detroit. The cold, the snow, the wind, the moisture were enough to make anyone want to move to Florida.
But, if you’re still around here are a few things to keep in mind if you’d like to keep away those HUGE heating bills that came along with last years’ brutal winter.
As the winter wore on, you might have seen or experienced Ice Dams (Ice filling up and blocking your gutters – illustrated in diagram below: